Australia: englishAustralia: english
International: english
International: englishInternational: english
Australia: english
Australia: englishAustralia: english
Austria: deutsch
Austria: deutschAustria: deutsch
Canada: english
Canada: englishCanada: english
Czechia: český
Czechia: českýCzechia: český
Denmark: dansk
Denmark: danskDenmark: dansk
Finland: suomi
Finland: suomiFinland: suomi
France: français
France: françaisFrance: français
Germany: deutsch
Germany: deutschGermany: deutsch
Hungary: magyar
Hungary: magyarHungary: magyar
Italy: italiano
Italy: italianoItaly: italiano
Netherlands: nederlands
Netherlands: nederlandsNetherlands: nederlands
Poland: polski
Poland: polskiPoland: polski
Romania: românesc
Romania: românescRomania: românesc
Slovakia: slovenčina
Slovakia: slovenčinaSlovakia: slovenčina
Spain: español
Spain: españolSpain: español
Sweden: svenska
Sweden: svenskaSweden: svenska
Switzerland: deutsch
Switzerland: deutschSwitzerland: deutsch
UAE: english
UAE: englishUAE: english
United Kingdom: english
United Kingdom: englishUnited Kingdom: english

How to: Surface sealing of bored pile walls

When sealing the surface of bored concrete piles, a flat surface is required, which can be achieved with the installation of the Pecafil® permanent formwork.

Separate layers, in front of bored pile formworks, are recommended for concrete saving and possible fine adjustment of basement walls in contrast to less accurate bored piles.

The sub-structure waterproofing system Zemseal® is applied where high-grade surface sealing is required - offering complete protection against moisture ingress. Zemseal® is applied to the flat layer of the Pecafil®, eliminating the need for subsequent crack injection - especially in concreted areas where access is limited or difficult.

How to:

  • Apply the Pecafil® sheets to the bored pile wall and secure with a nail gun or by using dowels.
  • Pre-fold the Zemseal® membrane for corner installation later on. After concreting the base slab, the Zemseal® sheeting should protrude approx. 500 mm upwards for easier connection.
  • Position the prepared Zemseal® corner profile, followed by the surface sealing for the floor, on the blinding layer.
  • Concrete the floor slab. Ensure that Fradiflex® metal water stop is installed in the construction joint between the floor slab and the wall.
  • Attach pre-cut Zemseal® sheets in strips with Zemseal® adhesive tape (50 mm). Gluing with vertical strips can be done at intervals of approx. 1000 mm (gluing on the protruding wire of the Pecafil® mats).
  • Reinforce wall, position wall formwork and concrete wall.

We recommend
Contact Contact

Max Frank Pty Ltd
1/42 Balaclava Street
Woolloongabba QLD 4102